If you’re planning DIY Carpet Installation in the office or at home, you have possibly seen the knee kicker. That annoying tool is generally used to hold the freshly installed carpet while it is stapled into place. It can be painful to wear and very tough on the knees eventually. I know what you are considering – I only want my new carpet.
How to Lay a Carpet without Knee Kicker?
For those who are doing a carpet installation coral springs and don’t want to use tools like stretchers or knee kickers, it is crucial to be aware of the risks associated with not using one. Not only can buckling occur, but it can also wrinkle from lack of support in particular areas.
If you still maintain on doing Carpet Installation without the knee kicker, I suggest that you wear slip-resistant shoes when laying new floors as they will assist in sure suitable footing while working on slippery surfaces. Here is the complete guideline to do it properly:
Clean Your Bedroom
Before laying the carpet, ensure that no dirt particles or substances remain in your room. I recommend that moisten a mop with water, then use it to clean up any debris around its perimeter.
Step 1 – Install the Adhesive Strips
If you are prepared to install the carpet, ensure the subfloor is in decent shape and all edges are covered with adhesive strips. This will assist in preventing moisture from seeping into any gaps or cracks below, so it will last longer. Adhesive strips are generally designed to be installed against the wall. While you’ll typically need to install them 1/2 inch apart, since you’ll be tensioning the rugs to fit snugly with no gaps or overlaps of any kind, placing them against drywall is also an option. Visit https://smartsportsfloor.com/6-tips-for-installing-carpet-by-yourself/ to read about 6 Tips for Installing Carpet by Yourself.
Step 2 – Cut and Lay the Carpet Padding
Now is the time to measure your carpet pad to ensure it has the correct dimensions required for Carpet Installation. Be sure to account for any width or height restrictions to avoid cutting pieces, then use a precision knife to make the cut. Then lay the mat on a flat surface with padding against the adhesive strips. Opening in one corner, start laying out fabric squares so they cover as much ground as possible. Then fold each edge strongly before tucking them firmly into place.
Step 3 – Cut and Lay the Mat
Cut the mat into perfect square footage. Keep in mind to use a cutting tool or sharp knife for an even cut. Then begin in the farthest corner of your room. Proceed towards this point, laying the rug down as you go until it meets an exterior wall or door frame.
Step 4 – Stretch the Carpet Using the Hop Method
When you are finished laying the mat down, go back to where there are adhesive strips and look over at them. Just use the momentum from your jumps to stretch wrinkles or tugs between pieces for a uniform look.
Step 5 – Attach the Carpet to the Tack Strips
Next, grab some work gloves and put them on. Lay the edge of the carpet over where you put those annoying sticky strips down so it will stick when you pull firmly with your hand on each end. Connect all four sides before moving on to another room.
Conclusion
You now know how to properly lay a carpet without a knee kicker. I have laid carpet several times without knee pads and it was amazingly simple. All you just need is a little time to get started on your Carpet Installation. Also, the key is to take the measurements properly so the edges of the carpet are easier to install when they are rolled on the floor.